Hello Guest it is November 30, 2021, 07:42:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jkan101

Pages: 1
1
General Mach Discussion / axis a set up in mach 3
« on: January 13, 2017, 06:40:32 PM »
Just got my 4th axis for my taig mill.....when into ports and pins and enabled axis a and also checked off dirlowactive.....went into the motor tuning and setup and entered all the info there........and I get nothing when I try to jog the a axis .......any ideas or did I miss something?


Thanks

Joe

2
General Mach Discussion / gcode issue
« on: July 31, 2015, 03:30:40 PM »
Whomever,
I have a problem when I run this gcode program it will only go to line 483 and stop there instead of going to the end. Even if I try to look at it in the window its open again it only goes to line 483 and stops but if I hit the edit gcode button I can see the g code all the way to the end of the line which is 761. Not sure if this is a Mach 3 issue or bobcad issue. Thanks

Joe

3
General Mach Discussion / simulate
« on: July 12, 2015, 11:56:20 PM »
Having abit of an issue with my mill...I  am new however I did setup my my mill,motors, controller and everything was working great. I turned everything on today and I noticed when I jogged that the dro was moving and not the motors.

I checked the control box and checked the reset button all was well....I went to the diagnostics page and noticed that under ---pulse frequency it said simulate..I never saw that before...usually there are numbers here...also in the Time in Int. it says +0.0. I must have put it into simulation somehow I dont know how----If someone would help me out I would appreciate it greatly.


Thanks


Joe

Pages: 1