1
General Mach Discussion / ramp problem on z axis
« on: November 08, 2016, 09:12:03 AM »
Hi
CNC 6040z 1.5 k
A week a go I try to calibrate z axis and was when the problem start.
If a make a z axis cut at 1 mm
It make a ramp from 0 to 1mm and stay there until have to go up after that start the same way 0 to 1mm and go on.
I use art cam pro and the ramp setting is in off the problem is when I run in mach 3 .
CNC 6040z 1.5 k
A week a go I try to calibrate z axis and was when the problem start.
If a make a z axis cut at 1 mm
It make a ramp from 0 to 1mm and stay there until have to go up after that start the same way 0 to 1mm and go on.
I use art cam pro and the ramp setting is in off the problem is when I run in mach 3 .