Hello Guest it is December 11, 2019, 09:43:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wozDaddy

Pages: 1
1
General Mach Discussion / MACH3 Demo
« on: June 23, 2015, 08:38:41 AM »
Hello,

Should I be able to test MACH3 software (demo) before I purchase ?

Here's my story ...... MACH2 will run my mill, XP only.  I downloaded MACH3 (demo), using a different pc
with Win 7 (no parallel port)  and a UC100 cable. When I start the software I have a choice for what cable to use.
I cannot get no machine response at all meaning, jog or sample program run.
Any help at all will be very much appreciated.

Thank you.

Pages: 1