1
General Mach Discussion / MM and Inch Motor setup
« on: August 15, 2015, 09:47:41 PM »
So I searched this bit but I am still confused. What I found didn't work.
So I have Chinese CNC they sent instruction that run it on MM, but I want set up a profile in inch's as well.
I know I have to make changes to the Motor Settings.
My Steps per are 320
Velocity is 1500
and Acceleration is 300.
I am not sure which way to times, or divide by.
Thanks for your help.
Matt
So I have Chinese CNC they sent instruction that run it on MM, but I want set up a profile in inch's as well.
I know I have to make changes to the Motor Settings.
My Steps per are 320
Velocity is 1500
and Acceleration is 300.
I am not sure which way to times, or divide by.
Thanks for your help.
Matt