Topics

1

General Mach Discussion / making Cont. Jog as default?

« on: May 23, 2013, 12:18:51 AM »

How can i make the change Continuous Jog as defalt; I have made to many crashes when I change from cont. to step jog mode & back -n-forth.....I'll forget to switch back to Cont. jog ,,,& when I do jog the amount I want, & I let off the button it keeps moving, I'll quickly try to hit esc key.. frustrated that I'm in the step mode.....  OK heres what I want to do,  when I do want to use the the Step Jog mode,  once it has made its move, I want Mach to automatically switch to the Continuous Jog mode..(I want to make it the default)     I have broken to many bits because of this.... Your help is very appreciated

2

General Mach Discussion / Need Help on indexing for router

« on: July 17, 2012, 11:16:30 PM »

What do I need to do so I can route longer materials on my router? My router table is 48" x 96".  the ends are open for what ever lengths of material.
How do I program Mach to restart the routing where it left off ?  I have a 10' sheet of aluminum to route a large oval , I will route the 8' of it. index it,
move the material over & resecure it .  This is where it is confusing to me on how to restart mach whereit left off,  your help needed , thanks   signguy

3

General Mach Discussion / wells index CNC 700 summit dana control

« on: August 16, 2007, 10:29:20 PM »

I have had this wells index mill for about 3-years , the only way I have been operating it is by jogging, programming does not work..  After having success with Mach3 on my
4x8 router I am now ready to get this mill operating on Mach3 as well.  The machine responds very well to the jog commands ,,,,Here's what I want to do,, Use existing drives
& steppers  ,I need a schematic so I can find the pulse input & dir  pulse.  (wells index CNC 700 summit dana control)  or if anyone has any other comments or suggestions
I would appreciate it .............thanx    signguy..

4

General Mach Discussion / Schematic for slo-syn SS2000D6 drive or replacement

« on: June 21, 2007, 08:33:00 AM »

Just got Mach3 up & running , then my z-drive went out (moves in 1 direction only)  The driver is superior elec. slo-syn drive.
I'm looking for a replacement ,  or a schematic for local tech to repair it.   need help