1
Third party software and hardware support forums. / optimum kontroller IV
« on: May 11, 2015, 02:37:08 AM »
I am totaly new to mach3 and I would like to use it on my optimum cnc mill. The contoll unit is called "controller IV".
Has anyone here done this before? It would be nice to get my hands on a config file for my control unit :-). If anyone have useful info I would be greatful.
Thanks
Tobbe
Has anyone here done this before? It would be nice to get my hands on a config file for my control unit :-). If anyone have useful info I would be greatful.
Thanks
Tobbe