Hello Guest it is October 03, 2023, 06:09:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - stevep43

Pages: 1
General Mach Discussion / Digitize led keeps flashing
« on: May 05, 2015, 07:49:15 AM »
Hello all:

I am trying to setup the tool centering and the zero plate scripts.  I am using Mach3 under windows 7 32 bit.  I have the probe on pin 13(i also tried 15) with active low.
The digitize led is for the most part off, however it randomly flashes.  I have change the debounce setting to the point where the led is mostly off, however when i run the center routine, i have the debounce settings so high that the script over shoots the contact point. Any help would be appreciated. Thanks. Steve.

Pages: 1