Guest
Show Posts
1
General Mach Discussion / GALIL WITH MACH3
« on: May 04, 2015, 06:16:49 AM »
Hi,
I am new in the Mach3. i am regularly using galil now we planning to make one 3D part producing machine (6 axis) with galil and mach3 interface.
in this i have the following doubts:
1.6 axis interpolation is possible in mach3 or not.
2.while using mach3 with galil any limitation is there? in the mach3.
3. its possible to run the threading program from mach3 via galil.
I am new in the Mach3. i am regularly using galil now we planning to make one 3D part producing machine (6 axis) with galil and mach3 interface.
in this i have the following doubts:
1.6 axis interpolation is possible in mach3 or not.
2.while using mach3 with galil any limitation is there? in the mach3.
3. its possible to run the threading program from mach3 via galil.