Topics

1

General Mach Discussion / Ethernet Smooth Stepper Problems - Stops at the same place EVERY time

« on: April 30, 2015, 10:01:29 AM »

I am running Mach3 with a smooth stepper on an old Dell Latitude Computer using XP. I am trying to do some 3d milling. When milling a piece of code that is short I do not seem to have problems. But on longer programs used for 3d milling it just stops with the "ran out of data" message.

I have run the special driver program, I have updated my computer to have 4 gig. of ram.

I don't think it is a windows interupt issue because it stops at the same line of code everytime,  Line number #238226. I have the look ahead set to 225.

Clueless where to look