Hello Guest it is July 18, 2019, 04:16:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ax2015

Pages: 1
1
General Mach Discussion / New versions and Feed hold bug
« on: April 22, 2015, 04:05:41 PM »
Hello. Been using Mach3 for a while and few times router has done something very weird. Today I experienced major crash using this sequence:
- while running gcode, press Feed hold
- move Z up to clear bit
- press Cycle start to continue

This should be a standard procedure and also described on manual. What happened was a move to an unknown position which caused a crash of course. There is a video on Youtube about the same procedure - and about the same crash...

I have .066 version. Any plans to fix those bugs since Mach3 hasn't gotten any updates since long time?
I have read posts about .067 dev version. Worth downloading (and from where)?

Axel

Pages: 1