1
General Mach Discussion / Wacky towards the end of G code
« on: April 19, 2015, 10:49:15 AM »
Hello All;
Hopefully someone can shed some light on my problem.
I run relief cut from Artcam. It takes from 3-8 hours to finish and towards the very end, when only few lines left to finish machine gets stuck. I tried changing orientation of a cut but didn't help.
Any help would be greatly appreciated.
Hopefully someone can shed some light on my problem.
I run relief cut from Artcam. It takes from 3-8 hours to finish and towards the very end, when only few lines left to finish machine gets stuck. I tried changing orientation of a cut but didn't help.
Any help would be greatly appreciated.