Hello Guest it is March 28, 2024, 11:21:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SeabeeGizmo

Pages: 1
1
General Mach Discussion / moving hove from lower left to right.
« on: February 21, 2019, 05:20:31 AM »
I have a new machine I am building and i want to have home in new location.

 Table display shows X right/left and Y up/down this part is OK. I need to have the home or table X0 Y0 in the lower right.

Regards
Gizmo

2
General Mach Discussion / Mach3 tool table
« on: October 08, 2015, 02:53:15 AM »
 ???

 I am new to Mach3 and looked through the forum but did not see anything about this.

 I have been running Aspire8 to make the G code and running my machine with Mach3 without much of any trouble. I tried to load the tool table and now Z is going nuts. If I have anything other then 0 in the Height field bad things happen. If you go down to auto 0 tool to the top of your work it goes up the amount you have in tool table height plus what I have set in auto 0 gadget.

 If I try to run a G code with anything more then 0 in Height it will try to drive the tool to Z 0, plus the amount in Height.

 What am I not seeing?

Regards
Gizmo

3
General Mach Discussion / Cycle Jog Step/Jog Mode not working
« on: April 06, 2015, 06:31:32 AM »
 ??? ??? ??? I am just starting out with Mach3/cnc stuff and at a loss.

 If I press TAB the MPG MODE come on. If you look at the Jog Mode (no light). Cycle Jog Step will not move through the steps in the Gen config. Key board will jog only in motor setup.

I have some more question on getting this thing started//running.

 Like the homing. grrrrr.  But one thing at a time. I have one of those TB6560 4V3 boards. I had to jump wires from where the parallel port is first connected to the board.  20 to com, 10 to LPT10, 11 to LPT11, exc..... Now the limit switches, Estop and probe are working.

Regards
Gizmo

Pages: 1