1
General Mach Discussion / Center zero setting
« on: March 26, 2015, 04:00:47 AM »
Hello, I had put my fireball v90 away for a long time. Recently I brought it out and have set some jobs on it. I can not for the life of me remember how to set it to run from the center of the piece. In the past I remember when I set my plaque on the machine, I would move the bit to the center and bring the bit down to contact the wood. I would then zero x,y and z. When I started the job it would go from there. For some reason I can't remember how to do that and it always moves to the upper right corner and starts. Any Idea what I am doing wrong?
Thank you in advance.
Mike in Kailua.
Thank you in advance.
Mike in Kailua.