Topics

1

General Mach Discussion / UC100 stopping

« on: November 29, 2021, 10:29:46 AM »

I have used Mach3 succesfully for several years now, However recently I've started getting problems with the UC 100.
After starting the cutting the UC100 suddenly stops and a notice comes up " UC100 not responding.  Check connections and restart Mach 3 "
I do as it requests ( no alternative) but of course upon a restart the cutter is totally in the wrong place. The macine has to go to zero.   Although this can be done it takes a lot of time to do so as to continue the program where it stopped and it's not always spot on etc.

Can anyone help???    It has been suggested that it may be suffering from noise !!! (electronic noise)  Could this be correct and how do I cure it?

Thanks to all

Bob

2

General Mach Discussion / Blank Screen

« on: March 19, 2015, 07:44:18 AM »

Hi Everyone,

I'm new to CNC and Mach 3 and have come across a problem.

I have loaded a[ the g codes in to Mach 3 but no picture of the item to be machined appears in the top right hand box of the screen.

Can anyone tell me what I'm doing wrong ?

Bob