Hello Guest it is March 28, 2024, 08:46:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ClarksonSig

Pages: 1
1
General Mach Discussion / Absolute Machine Coordinates Shifting??
« on: March 09, 2015, 01:43:44 PM »
Hello,

I'm new to Mach3 so forgive me if I do not use the correct jargon. But here is my issue:

I've set the work coordinates G54 as (let's say) X=1, Y=1, Z=1 in absolute.
Now from what I'v figured out, each time I open Mach3 it will use G54 as a default work coordinate system.
So G54's zero should be at Machine Absolute's X=1, Y=1, Z=1.

But each time I close and open, G54's zero is now at something like Machine Absolute X=.5, Y=.5, Z=1.

Why might this shift be occuring? How does Mach3 come up with the Machine's Absolute Coordinate's upon boot up? Am I wrong to have expected it to be the same each time?

Thank you,

Corey

Pages: 1