Topics

1

General Mach Discussion / G code with user variable

« on: October 17, 2019, 06:39:57 PM »

Hi..am looking to run a simple program that would move in x a certain distance, then stop..z up.. and ask user for a second y position before continuing...have mach 3 in xp

Thanks

2

General Mach Discussion / power outage problem

« on: December 11, 2016, 02:59:02 PM »

Hi...after power outage ,one motor is not working...is therea reset for drivers..bob?....thanks

3

General Mach Discussion / help needed

« on: December 01, 2016, 06:37:14 PM »

Hi...hope someone can help...I have a problem with my 3 axis cnc router...
anytime the z axis goes up,followed by a postive direction move in xy at the same time (angle)..xy stalls and loses position..if z is moved down any amount the problem goes away.

I actually made a workaround for rapid travel by moving z down a smidge before any other motion.....problem is now I am  doing some ramp in and out and I am losing position

4

General Mach Discussion / jog problems

« on: June 15, 2016, 03:34:33 PM »

Hi all....have an unusual problem using mach 3....hoping someone can help....if z is jogged up , then go x+,y+....about every 4 inches x,y almost stop then go 4 inches,repeat....if then z jogs down..no problem....any HELP?

5

General Mach Discussion / axis stall

« on: January 27, 2016, 02:44:18 PM »

Hi all.....peculiar problem.....if i jog Z up...then go x+y+ at the same time.....xy stall....if i then jog z down...no stall in same direction..
backlash is not on

6

General Mach Discussion / atc spindle setup

« on: August 15, 2015, 12:36:37 PM »

Hi...I am trying to set up a 5.5 kw atc water cooled spindle....bought used and can't find good info on wiring etc....

Anyone know setup Video) of 24v sensor at top of spindle to pc?..any overall help greatly appreciated....thanks

7

General Mach Discussion / adding ramp in

« on: March 08, 2015, 07:52:18 PM »

Hi all....wondering if it is possible to add a ramp in move to post processor for gcode i am getting that does not have that feature....thanks