Topics

1

General Mach Discussion / Issue with X & Y

« on: December 23, 2015, 12:17:28 AM »

Using Mach3 just installed a tb6600 and 3 HY-DIV268N-5A.. All is working correctly except on my keyboard for my laptop I normally use the arrow keys to jog the X & Y. They do move but the up arrow normally moves the X, but it moves the Y and the right arrow moves the X not the Y.
 Any ideas of how I can fix this?

2

General Mach Discussion / Newbie Issues

« on: March 06, 2015, 08:27:01 AM »

 Ok not sure if this is the correct place for this post and sorry if its not, but here goes.
New to this but am having issues getting the .TAP file to show up correctly in Mach3.
I created a file with Cut2D, sent it to LazyCam, set all the values needed and posted it to Mach3.
In Mach3 it is super big and 95% of the image doesn't even show on the image display.
 What am I doing wrong?
I am adding the lazycam file, if you can fix it or tell me what I did wrong I would greatly appreciate it!!

 I am using a 0.050" DIAMOND CUT CARBIDE ROUTER BURR
 Cutting 30"x20" 3/16 thick dollar tree foam board

Any help would be great
Thank you!