Hello Guest it is March 28, 2024, 05:22:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bar553

Pages: 1
1
Mach4 General Discussion / Error meanings
« on: December 16, 2023, 11:50:04 AM »
I am running Mach 4 Lathe and have been getting errors that I need to understand what they are telling me so I can try to fix.

I have a Pokeys 57e controller. 

Thanks for the help.

BAR

2
Newfangled Mill Wizard / Newfangled Mill Wizard Tool path display blank
« on: January 15, 2018, 02:35:31 PM »
The wizard produces the gcode and all, but does not display the path in the center window.   Any ideas.?  Running version 2.0.4x on a windows 7 platform.

3
Mach4 General Discussion / Mach4 / Darwin setup
« on: April 02, 2015, 04:45:16 PM »


 Ok for the brainy people.....

I have a 3020, on an XP machine. With a Parallel port.  I have Mach 3 set up to the point of being able to move the motors.  all three axis work.  I also have Mach 4 and Darwin, that I want to use to learn it, while I work on a Mill build.

I have all the same port settings and pin settings in both versions. 
In Darwin setup, I get indicator light changes on the port page, when I jog the motors.
I get green indicators and movement on the velocity indicators on the motor tab.
I get a reset change when I hit the estop on the controller box.

BUT... I get no physical motor movement in Mach4

So I'm at a loss of what to try next.

I would appreciate your thoughts

BAR

Pages: 1