Hello Guest it is March 28, 2024, 09:18:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - heliman666

Pages: 1
1
General Mach Discussion / Slave axis is not moving on G-code
« on: February 16, 2015, 08:11:34 PM »
Hello All,

I am new to the forum and i will thank everyone in advance for help with this question.

I am running Mach 3 with a breakout board (PBX-RF rev 4.1) and 2m542-06 controllers. my OP system is windows XP W/ service pack3.

everything works in my setup and i have A slaved to my Y axis.  A&Y work together when i jog the Y axis. they all home properly
BUT when i load the G-code and it runs only the Y axis moves! Z,X AND THE SPINDLE WORK BUT the A wont move when running the code.

any help would be great.
thank you.....Adam  

Pages: 1