Hello Guest it is March 29, 2024, 08:15:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - egander1

Pages: 1
1
I am setting up a CNC 6040z-4s mill and the controls for the Z-axis stepper motor are reversed.  I went to the config->system hotkeys and selected page up for the Z++ and page down for the Z-- and they are reversed from what they should be.  I can reverse the hot keys assignments by selecting page down for Z++ and page up for Z-- but I am wondering if that is the correct way to correct this.  Is there some other method that this should be corrected.  Thank you.

2
Just received a CNC 6040z 4s mill and what little instructions I have found it is suggested to use a rust inhibitor in the water.  Wondered if antifreeze would work for this and what percentage if it does or if there is another product anyone would recommend to use. 

I am also planning to use distilled water but was wondering if this was necessary.

Thanks.

Pages: 1