Hello Guest it is November 21, 2019, 02:07:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dukie94

Pages: 1
1
General Mach Discussion / Homing/limit switches
« on: May 10, 2016, 02:54:07 PM »
Hello,
A few weeks ago I turned on my machine hit Ref. home z went up and did not stop. No signal to switches X,Y or Z.
I could still jog all the Axis and also run the machine just could not Ref. Home.
I thought it might be the motion card I have leafboy77 in my machine.
I bought a new board ( mach3 motion card) but had not installed it yet.
Yesterday I turned on the machine hit Ref. Home Z got a signal and so did Y but not X.
Went to home depot came home hit Ref. Home and wow all three switches got a signal.
Thought all was good.
Turned on the machine this morning and no signal on any of the switches.
Is my problem Mach3 or is it the motion card?
Thank you,
Philip

2
G-Code, CAD, and CAM discussions / Mach3 Cam/cad
« on: May 04, 2015, 03:15:53 PM »
I just bought a cnc machine. I need help setting up mach3.
How to convert from vectric to mach3?
Thank you,
Phil

Pages: 1