1
General Mach Discussion / I say inches mach3 cuts in mm
« on: February 02, 2015, 11:59:09 AM »
I have made several attempts cutting a simple tool path but when my dimension is 5 inches my router cuts 5 millimeters...
I am using Vectric cut2d to draw and save toolpath. It gives me four options to save for mach3, 2 in inches 2 in mm. All four are ".TXT" files.. have tried all for and each time my finished cut are a tiny version of my drawing. I draw in inches format and my native units in mach 3 are inches. I tried drawing a simple 5 inch square and my machine cuts a 5 mm square. if anyone has any ideas or suggestions I would be tremendously grateful..
thank you
I am using Vectric cut2d to draw and save toolpath. It gives me four options to save for mach3, 2 in inches 2 in mm. All four are ".TXT" files.. have tried all for and each time my finished cut are a tiny version of my drawing. I draw in inches format and my native units in mach 3 are inches. I tried drawing a simple 5 inch square and my machine cuts a 5 mm square. if anyone has any ideas or suggestions I would be tremendously grateful..
thank you