Hello Guest it is March 29, 2024, 09:20:39 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CNC_Guitar

Pages: 1
1
General Mach Discussion / Slow ZOne settings not working
« on: February 24, 2023, 12:59:56 PM »
I read a lot about how to use the 'slow zone' settings and function but unfortunately, I can't get it working for my machine.
The attachment shows the homing and limit settings and that the soft limit button is enabled.
When jogging at full speed, the axis are not slowed down.

What am I doing wrong?

2
Hi All,

I used the demo file "scorpion.tap" to test my router table.
This file is part of the Mach3 demo version.
When the g-code is processed and the mill has to go back to it's zero point , it happens that the Y-axis motors (slaved-axis) seem to jam (it does'nt sound good  :'().
The result is that the Y-axis does not go back to zero and I need to home the table again.

I'm quite sure that the settings in Mach3 are ok and both motors (y- and slave axis) are tuned exactly the same.
Jogging (fast/slow) and homing works ok.

Does somebody have an idea what could cause this problem?


Pages: 1