1
Mach4 General Discussion / Migrate from Mach3 - 4 (XYYZ) CNC
« on: October 02, 2016, 02:40:27 AM »
Hi Everyone
I think it is time to give Mach4 a try again. I did when it came out but had no success.
Are there anyone that have done this successfully to gibe me pointers, or even better is there a way to migrate my Madh3 config to Mach4?
I remember I had a problm to hpget tje Dawin parallel port emulator to,work.....
Rgs
Scalci
I think it is time to give Mach4 a try again. I did when it came out but had no success.
Are there anyone that have done this successfully to gibe me pointers, or even better is there a way to migrate my Madh3 config to Mach4?
I remember I had a problm to hpget tje Dawin parallel port emulator to,work.....
Rgs
Scalci