Hello Guest it is April 01, 2020, 07:57:50 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Damin69

Pages: 1
1
General Mach Discussion / AutoZ Issue
« on: February 21, 2015, 08:16:11 PM »
Auto Z was working just fine. Now it will not work properly. When I click on my auto z button the bit comes down about 1/8" then pulls up the the retract distance and says that Z is Zeroed. But it is not. I have tried redoing the script using a completely different script same issue. I have rebooted and restarted everything does it every time. Any suggestions?

Pages: 1