Guest
Show Posts
1
Newfangled Mill Wizard / Question from a novice
« on: January 04, 2015, 04:34:14 AM »
G'day all,
As my subject title says, I'm a novice.
Mill Wizard was recommended to me by a machinist, that knows what I'm trying to do.
I've done a lot of machining by "hand", but the only thing I've worked out about G-Code is, that it has nothing to do with finding the G-Spot !
As a complete novice, would it be too much to ask for a couple of videos, to make life a little easier.
I know a lot of this stuff may seem terribly elementary to some, but It's a bit daunting for us novices.
Thanks for your time.
Michael
As my subject title says, I'm a novice.
Mill Wizard was recommended to me by a machinist, that knows what I'm trying to do.
I've done a lot of machining by "hand", but the only thing I've worked out about G-Code is, that it has nothing to do with finding the G-Spot !
As a complete novice, would it be too much to ask for a couple of videos, to make life a little easier.
I know a lot of this stuff may seem terribly elementary to some, but It's a bit daunting for us novices.
Thanks for your time.
Michael