1
Mach4 General Discussion / Powtran PI9000 vfd, need help please.
« on: December 13, 2017, 07:33:32 PM »
Hi, I have been converting a lathe I bought to cnc.
I fitted a Powtran PI900 2.2Kw, 240v single phase in and 240v 3 phase out, also I have fitted an ESS and MB2 board I purchased from cnc room and it all runs on Mach4, the problem I am having is I want to connect the vfd to the ess and be able to control the css of the motor through mach4.
I have read the manual that came with the inverter and I can't figure out which connections to use from the vfd to the ess
I would appreciate some help if anyone has had experience with a Powtran vfd.
Thanks Peter
I fitted a Powtran PI900 2.2Kw, 240v single phase in and 240v 3 phase out, also I have fitted an ESS and MB2 board I purchased from cnc room and it all runs on Mach4, the problem I am having is I want to connect the vfd to the ess and be able to control the css of the motor through mach4.
I have read the manual that came with the inverter and I can't figure out which connections to use from the vfd to the ess
I would appreciate some help if anyone has had experience with a Powtran vfd.
Thanks Peter