Topics

1

Newfangled Mill Wizard / Machine Max Limits

« on: December 15, 2014, 11:25:30 AM »

Am I over looking something? I can not find how to save the Machine Max Limits??
Does this have to be set every time you open the software??
Thanks

2

Newfangled Mill Wizard / MillWizard Exit

« on: December 14, 2014, 10:12:20 AM »

I have a strange problem. I down loaded and installed Mill Wizard a few days ago and played around with it and no problems. Last night I purchased a License and installed as
per the instructions no problems. When I was ready to exit Mill Wizard it would not close?? I tried to close it with Task Manger and still it would not close. So after a little break I when back to the
shop and was going to work on another project when I opened the new project Mill Wizard close as if I just told it to exit???
So I opened Mill Wizard again and the same, the only way I can exit is after clicking exit and confirming I want to exit, is to try and load another project?
Thanks for any help on this problem.