Hello Guest it is March 29, 2024, 04:40:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tbowen

Pages: 1
1
General Mach Discussion / Feed rate changing
« on: December 03, 2014, 01:20:37 PM »
If I click Stop or Reset while my g-code is running, the feed rate changes to 7.5 and stays there until it hits another feedrate change command in the code.  Any ideas? xml attached.

Pages: 1