Hello Guest it is March 29, 2024, 01:36:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Quentin David Lock

Pages: 1
1
General Mach Discussion / all toolpaths being magnified
« on: December 20, 2014, 08:19:24 AM »
Hi

I am a newbie and starting with a basic set up. I am using ventric 2d cut, mach3 on a small 6040z table. I have spent a lot of time setting up as per the mauals etc but now I have turned on and loaded my toolpaths I have the following problems and cant seem to see where I  have gone wrong.

All the axis are magnified. If the maach 3 says that the spindle has moved 230mm on x axis it has actually moved 290mm. same on y axis. on z axis programmed for 9.7mm mach 3 says travelled 9.7mm but has actually travelled 11.5mm.

It is probably something basic but have got myself bogged down as to what I should be looking at. (ventric,mach3 or machine set up.

Please help ??? ??? ??? ???

Pages: 1