Guest
Show Posts
1
General Mach Discussion / dyna myte 2800 with mach3 help needed
« on: November 25, 2014, 09:47:00 AM »
Hi!
I am eduardo, I'm from Spain
I recently bought a dyna myte 2800 and want to change it to mach3.
I have no manual and I don´t know too much about make this change.
I know someone here has already made the switch, could someone help me with the wiring?
I purchased a breakout board and also plan to use the original drivers and steppers
I would greatly appreciate anyone could help me, give me some information or send me the manual.
many thanks and greetings
I am eduardo, I'm from Spain
I recently bought a dyna myte 2800 and want to change it to mach3.
I have no manual and I don´t know too much about make this change.
I know someone here has already made the switch, could someone help me with the wiring?
I purchased a breakout board and also plan to use the original drivers and steppers
I would greatly appreciate anyone could help me, give me some information or send me the manual.
many thanks and greetings