Guest
Show Posts
1
General Mach Discussion / config mach3 for PCB engraving
« on: November 24, 2014, 02:49:00 PM »
hi
i have one more question :
i have done with my pcb with eagle and already has the G-CODE file for the tracks and drilling etc
my problem is when i load the file in mach what i have to do to get my pcb done ex:
how i set the zero point of a workpiece ?and if i did does that mean the mach will start cut and..etc from this poitn or it will navigate to somewhere else? and how can i tell mach to stic with the design !voz when i load random gcode from mache default folder some of the axis goes far way of it's limit ?
correct me if i am wrong but doesn't it the mach will never go far of (the axis) as long as my design within the range of my table ?
my table overall size is 550mm*500mm (not the working area it's over all the aluminum plate the it hold my piece which i mean my working area it might be between 450*490( + - )?
:p
i have one more question :
i have done with my pcb with eagle and already has the G-CODE file for the tracks and drilling etc
my problem is when i load the file in mach what i have to do to get my pcb done ex:
how i set the zero point of a workpiece ?and if i did does that mean the mach will start cut and..etc from this poitn or it will navigate to somewhere else? and how can i tell mach to stic with the design !voz when i load random gcode from mache default folder some of the axis goes far way of it's limit ?
correct me if i am wrong but doesn't it the mach will never go far of (the axis) as long as my design within the range of my table ?
my table overall size is 550mm*500mm (not the working area it's over all the aluminum plate the it hold my piece which i mean my working area it might be between 450*490( + - )?
:p
