Hello Guest it is November 28, 2021, 07:35:20 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Sailor10

Pages: 1
1
G-Code, CAD, and CAM discussions / CV and exact stop
« on: August 24, 2020, 09:38:21 PM »
I read in your manual, much after I sent the request that G61 and G64 can be used. One turns CV on the other Turns exact move on. 

My problem that caused the inquiry is:  On a clock face that is about 11 inches in diameter, I inscribe two circles out at about 10.25 and 10.5 inches in diameter, between them I inscribe the minute and hour marks, 48-minute marks which are shorter and 12-hour marks which extend from the inner circle to the outer circle.  In the first quadrant +, between 1 and 4 the marks are almost parallel to the line between the center and the 3. In the last quadrant between 9 and 12 the form a crescent shape.

I am trying to determine why this is happening as I can't cut clock faces with funny looking minute and hour markers.  It does not appear that I am losing steps as the end of the cut ends exactly at the beginning.

As CV is the default, I cut my speed down from 80 in/sec to 25, thinking it was rounding the last of the cut. (didn't make a lot of sense as half of the cuts were fine.) but worth a try.

Any suggestions would be appreciated.

Regards,
Ken Hall
Quad 1.jpg
Quad 3.jpg
Quad 4.jpg

Pages: 1