Hello Guest it is March 28, 2024, 02:32:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jolbe

Pages: 1
1
General Mach Discussion / Only one direction pin! Please help.
« on: June 03, 2007, 11:24:01 AM »
Hi,

First excuse my English.
I'm using retrofit kit from Wabeco and I don't like DOS software that was shipped with retrofit kit. I tried to setup mach3 working but had a little success.
I think problem is that stepper control board is only using one direction pin. When I try to move X and Y axis at same time where X and Y  axis have different direction pulses  then steppers loose many steps. It works fine if both axis have same direction output.

my configuration:
X dir pin: 1
X step pin: 14

Y dir pin: 1
Y step pin: 16

Z dir pin: 1
Z step pin: 17

Is there any solution for such problem or do I have to buy new stepper controler board that have seperate dir/step pins for each axis.

Please help

Pages: 1