Guest
Show Posts
1
General Mach Discussion / Motors not following properly after XP re-install
« on: October 10, 2014, 12:32:21 PM »
Hi guys,
I've had to re-install XP and Mach3. Before the crash, everything worked fine but now after configuring everything, pressing the left and right direction keys sets the mill in motion in the same direction (so both X++) and pressing the X-axis keys causes the mill to move in one and the same direction along the Y-axis. I've checked all the hotkey-settings, motor output settings, pinouts etc. which is basically all standard. What am I missing here?
Thnx in advance for your input!
Cheers,
Rene
I've had to re-install XP and Mach3. Before the crash, everything worked fine but now after configuring everything, pressing the left and right direction keys sets the mill in motion in the same direction (so both X++) and pressing the X-axis keys causes the mill to move in one and the same direction along the Y-axis. I've checked all the hotkey-settings, motor output settings, pinouts etc. which is basically all standard. What am I missing here?
Thnx in advance for your input!
Cheers,
Rene