Hello Guest it is March 28, 2024, 04:53:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jordi

Pages: 1
1
General Mach Discussion / Use the buttons to jog Mach3 with Arduino
« on: October 01, 2014, 01:12:20 PM »
Hello
First of all I must tell you that I am a newcomer here and I apologize in advance for my bad English.
I have one problem with my project. I am working on a plotter, which is based on CNC. For controlling i'm using Mach3, and i wanted to jog my stepper motors via buttons. But when i wired my parallel port from PC and output signal from Arduino with Step pin from stepper motor driver, the signal from Mach3, stoped working.But when i disconnect the arduino output signal, the signal from mach3 started working again. Can anyone tell me why does it work like that?

Pages: 1