Hello Guest it is April 18, 2024, 10:42:59 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - phinsil6

Pages: 1
1
Mach3 under Vista / Win 7 Mach3 not communicating with PCI PP
« on: September 11, 2014, 11:39:36 PM »
Hello, I am demo'ing Mach3 with my gSheild, typically I use grbl but i'm attempting a transition to Mach3.  A while back i bought a Rosewill PCI PP.  When I checked in resources tab, i get an address of EC00.  I entered that into Mach3Mill and Mach3 doesn't seem to be communicating with the PP.  I have a Win7 32 bit OS.  I ran the driver test as an admin and the driver test shows an "excellent system" with 100kHz.  When I look at Diagnostics Tab and try to jog the machine, none of the "Port 1" pins show any lights, but then again I don't even know if they even should.  I also have the BIOS set to ECP DMA0.

Any thoughts?

Pages: 1