1
Newfangled Solutions Mach3 Wizards / Controlling the toolchanger through Mach 3
« on: September 04, 2014, 11:34:03 AM »
I just got a used Emco Turn55 lathe. I am replacing the stepper controller with a Gecko 540 and plan to run it with Mach 3. My dilemma is how to control the 3 position toolchanger. The toolchanger requires approximately a 1 second signal to move 1 position. Can a macro be written in Mach 3 to use one of the Gecko outputs to move it on a tool change command? Any suggestions would be appreciated!