Hello Guest it is March 28, 2024, 06:03:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rad1945

Pages: 1
1
Newfangled Mill Wizard / Failure to load Mill Wizard License File
« on: September 01, 2014, 03:04:15 PM »
Hi People,
So many changes at one time makes things harder than they should be.
Have changed computers on my mill.
Have upgraded the new "mill" computer to have the requisite .net files.
Loaded my licensed version of Mach 3
Operated the mill with this computer and Mach 3, all okay apart from no "Blue Screen" yet.

Satisfactorily loaded the NFS mill wizard.
Attempted to load the NFS Wizard License File with the following (bad) results.
1. If I select current user it replies that "it is unable to copy the INF file".
2a. If I select "administrator" (which is me and has no password)
or
2b, If I select myself by name as the administrator (and still without a password)
It replies with "the service cannot be started because it is disabled or because it has no enabled devices associated  with it."
The reason there are no passwords associated with the user of this computer is that it is NEVER connected to my home network or to the Internet.
The only method by which it receives files is by the use of thumb drives which are loaded with the files. scanned and then loaded to the mill driver computer.
Sincere thanks in advance for any assistance at all.
Just a little by the way, the mill is stopped and my piggy bank is collecting cobwebs whilst this is happening. Doesn't it always happen!!
Russell Dunn
Ferlach,
Austria




Pages: 1