Hello Guest it is February 24, 2024, 06:48:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - EddieO

Pages: 1
General Mach Discussion / Screen Error with turn wizard
« on: August 28, 2014, 03:09:18 PM »
I am working on setting up a new machine(still working on it), while trying to learn mach3. Running in demo mode on my home PC not hooked up to a machine. When I load the turn wizard, I get the following error with the wizard where the buttons at the bottom are cut off on the screen regardless of what I do to try to move it.

Here is a screenshot.


The error replicates on the computer for the machine as well as not being able to adjust it....in fact it cuts it off more where I barely can see the buttons.

The turn wizards are a big reason I am considering mach3 to run the machines, but I can't figure this out.

I am sure its something easy I am missing thats simple....any help would be great.

Pages: 1