1
General Mach Discussion / Noob problem: zero not working
« on: September 22, 2015, 11:18:14 PM »
So, pretty straight forward I think. Mach demo installed and was working fine. All of a sudden though all axis are way off and when I click on 'Zero X' for example in the program run screen, nothing happens. If I try to manually enter '0' in the corresponding field and hit enter it just reverts back. I've looked through the manual to try to find anything that could be causing this and have come up blank. I'm assuming it's something simple I'm missing but I've spent a frustrating few hours trying to figure this out without luck.
Any suggestions?
Any suggestions?