Hello Guest it is December 15, 2019, 08:48:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - patton

Pages: 1
1
Mach4 General Discussion / Lua Question
« on: February 20, 2015, 11:09:30 AM »
Hello All,
  Is there some way to put 2 functions in a script and be able to choose which function you want to run using a checkbox control and it would run one or the other but not both?  I am not a computer programmer at all.

Thanks
Dave

2
Mach4 General Discussion / Need Help with Darwin and Spindle DRO
« on: December 09, 2014, 07:58:59 AM »
Hello all,
 Iv'e been trying to get get a spindle RPM DRO working for awhile with Darwin. on the diagnostic tab you can see the index led flash when the spindle is running. but I can not figure out how to turn that pulse into a DRO value on the screen. if you open diagnostic logging you can also see the signal change from 1 to 0 continuously. so at this point is this even possible to do?

Pages: 1