1
General Mach Discussion / Motor whistling only with Mach3
« on: August 12, 2014, 04:36:02 PM »
Hello,
I have just built my home-made CNC and I have a set-up problem, I guess.
When I'm using my CNC with my manual interface, no noise. However, when I launch Mach 3 - it means I desactive the Reset button - my stepper motors make a strange noise. Even if that noise don't impede my stepper motor to work, it's quite... annoying.
Do you have any ideas where the problem could be ?
Thank you for your time !
I have just built my home-made CNC and I have a set-up problem, I guess.
When I'm using my CNC with my manual interface, no noise. However, when I launch Mach 3 - it means I desactive the Reset button - my stepper motors make a strange noise. Even if that noise don't impede my stepper motor to work, it's quite... annoying.
Do you have any ideas where the problem could be ?
Thank you for your time !