Hello Guest it is March 29, 2024, 10:34:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cnchound

Pages: 1
1
hello,

i had been using an old version in a friends workshop (v2) and in there i could switch between viewing the whole table and just the Gcode workarea by using the display mode button.

I just purchased the latest version of Mach3 and cannot find a preference or setting or similar function to do this. Zooming in with themouse wheel is very impractical and i sure would like to have this 'old' feature back.

what am i missing ?

Pages: 1