Topics

1

General Mach Discussion / Anyone in Bloomington, INDIANA area using Mach 3?

« on: July 19, 2014, 02:11:40 PM »

We're having some trouble with getting our Mach 3 set up to communicate with our new 3-axis CNC Router.  Would appreciate connecting if your near Bloomington, IN.

Thanks!

2

General Mach Discussion / CNC Machine won't respond to Mach 3 PC commands

« on: July 18, 2014, 02:41:32 PM »

Hello, I just purchased a 3-Axis CNC machine with Mach 3 (64 bit) control drivers on it.  We downloaded the "trial version' of Mach 3 and can not get the CNC Machine to respond to the PC.

Is this because we are using the "TRIAL VERSION" of Mach 3?  Or is there something else that could be causing this disconnect?

ANY GUIDANCE WOULD BE GREATLY APPRECIATED!

Thanks