Hello Guest it is November 30, 2021, 07:10:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rustyh

Pages: 1
1
General Mach Discussion / Run Mach 3 on an old old CNC
« on: July 08, 2014, 06:27:13 PM »
Apologies if I have got the wrong section for this question,  I wasn't sure where to ask.

I was wondering if it was at all possible to get a very old (1986) Matchmaker 600 cnc mill working with mach 3?
Would I need to update the drivers, and if so what do I need to look for?

Thanks

Rusty

Pages: 1