Topics

1

General Mach Discussion / loading G code

« on: February 16, 2016, 07:56:50 PM »

Today I ran several new files through Sheetcam exactly as I have many times. When I went into Mach 3 to bring the files in, one at a time, to cut, the G code would not load.  I few lines did load but it is not the G code for the files.  I was able to cut the files by going straight from Sheetcam into Mach 3 immediately upon saving the file after posting.  I then tried to load G code from previously cut files, some of which I have cut many times, with the same result.  I must have inadvertently changed some setting, but cannot figure it out.  When I click on the file name to download the G code, just a few lines appear, but they are not the G code.  Any help is appreciated.  Thanks

2

General Mach Discussion / Assistance needed $$

« on: September 29, 2014, 08:27:15 AM »

I need someone familiar with Sheetcam and Mach3 to help me get my drawings free from the "could not place leadins" and "all cut paths not generated" warnings and acceptable to Mach3. I will be glad to pay a good hourly rate. Someone within 200 miles of upstate SC would be perfect, if not we can work together by email. One-time help would be appreciated, but I would like to develop a long term arrangement beneficial to us both. Thanks.

3

General Mach Discussion / Help

« on: July 08, 2014, 01:00:54 PM »

I am in north western SC and looking for someone within a few hundred miles using Mach 3 for plasma cutting and/or routing.  I want to come look.  Thanks, any help appreciated.  Jimmy Williams  jwiljrj@netscape.net  803 533 8000