Hello Guest it is March 29, 2024, 01:31:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - chad.moore

Pages: 1
1
General Mach Discussion / Need help with Pins and Port configuration
« on: July 03, 2014, 04:08:12 PM »
Hello all i am new to mach3 and am currently trying to set up a plasma machine with a slaveX/A axis.  In the (config/ports and pins/motor output screen) enable and disable motors works, but pins does not.  Doesn't matter which pin i assign or simply a 0 and when jogged the same incorrect motor will move.  Please help.  Thanks.  Chad Moore

Pages: 1