1
General Mach Discussion / XYZ have gone nuts again : MAch 3 and Chinese cnc 5040
« on: August 27, 2015, 01:10:31 PM »
Hello.
router have been running fine for a year or so.
But recently I started getting terrible drift on the Z axis...cutter going down an inch even on a shallow cut.
So I uninstalled and re-installed the software.
NOW it has got really bad.
Even with correct ports and pins and motor setup for my machine...the X, Y and Z arrow keys dont work the way they should.
X moves in same direction for both keys.
The Z buttons move the Y to the top when pressing either button.
And the Y buttons do nothing at all.
CAn anyone help with this?
Thanks,
Simon
router have been running fine for a year or so.
But recently I started getting terrible drift on the Z axis...cutter going down an inch even on a shallow cut.
So I uninstalled and re-installed the software.
NOW it has got really bad.
Even with correct ports and pins and motor setup for my machine...the X, Y and Z arrow keys dont work the way they should.
X moves in same direction for both keys.
The Z buttons move the Y to the top when pressing either button.
And the Y buttons do nothing at all.
CAn anyone help with this?
Thanks,
Simon