Hello Guest it is May 06, 2021, 03:44:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CCSINC

Pages: 1
1
General Mach Discussion / USING INPUTS WITH WARP9 SMOOTH STEPPER
« on: October 17, 2014, 06:01:27 AM »
I need to add more inputs for limit switches. Mach 3, warp9 ss, windows xp, LAPTOP. I used the warp9 pinout addresses (port 3, pin 1-3, etc) in port and pins but I do not get any signal on the diagnostics page when operating the limit switch. Does mach 3 recognize port 3 or am I supposed to check something somewhere in mach 3 so it does.?  Whats the difference between single ended and differential inputs?

Pages: 1